Posts by Alex

I always passionate for the challenge that all my project gave me. I spend every weekend and weekdays working on home projects of various kinds with new products and technology. This is the site where I share all of the projects and tips I’ve done and things I’m learning.
what size of water heater do i need Handy Tips

What Size Water Heater Do I Need?

Choosing the wrong water heater size could leave you either scalding in a sea of hot water or shivering under a cold shower, so getting it right is essential. When deciding on the size of your water heater, you need to take into account several key factors. For starters, your household size and the number […]

By Alex October 1, 2025
Handy Tips

This Is Why Your Drill Bit Keeps Slipping

Drilling is not without complications, and one of the most frequent is the drill bit sliding. This is generally not a drill fault, and therefore is a simple repair. How can you prevent this from happening? Your drill bit keeps slipping because the chuck is worn out and cannot hold the drill locked in place. […]

By Alex October 1, 2025
Handy Tips

This Is Why Your Hammer Drill Won’t Go Through Brick

Ideally, a good hammer drill will create holes in brick easily. With the right tools and correct technique, it should take only a little pressure and only a matter of seconds for a perfect pilot hole. If you’re encountering resistance, it’s time to look at your hammer drill and hole-drilling approach. Your hammer won’t go […]

By Alex October 1, 2025
Handy Tips

Why Drywall Screws Pop Out, How To Fix & Prevent It

At some point, you are going to see cracks and screws popping out in your drywall. Unfortunately, they are quite common and can be an eyesore, but many people would agree that they are inevitable. An average house requires around 25,000 to 35,000 screws, and while a dozen popping out is a normal occurrence, why […]

By Alex October 1, 2025
Handy Tips

Here’s Why Your Drill Bit Stops Spinning (With Fixes)

Drill bits are essential tools when it comes to cutting patterns and shapes into different materials. When the bit doesn’t spin, a lot of work can remain undone until you solve the problem. What are the possible causes and how can you fix them?  A drill bit can stop spinning if it’s wrongly inserted or […]

By Alex October 1, 2025
cost labor installation water heater Handy Tips

How Much Does It Cost to Install a Water Heater?

Installing a water heater can cost you anywhere from $960 to $3,910, with most homeowners paying around $2,200. This wide range is due to various factors, including the type of water heater, its fuel source, and the complexity of the installation. If you’re considering replacing your old water heater, you’ll need to factor in not […]

By Alex October 1, 2025
Handy Tips

Can a Generator Run a Gas Furnace?

Power outages happen all the time, especially during bad weather like snowstorms. If your power goes out during a cold winter, you will want your furnace to continue running so your house stays warm. Is it possible to use a generator to keep a gas furnace running? A generator can run a gas furnace provided […]

By Alex October 1, 2025
Handy Tips

Can a Hammer Drill Drive Screws? (It Depends)

Many people have a standard drill, but fewer people have a hammer drill in their toolbox. If you want to use a hammer drill, you need to know when you can use it. Can you use a hammer drill to drive screws, and can a hammer drill remove screws? A hammer drill can drive screws […]

By Alex October 1, 2025
Outdoor

Are Lawn Tractor Baggers Universal?

Buying a lawn bagger for your tractor can be a tricky affair, especially if doing so for the first time. Similarly, using it comes with its share of challenges, such as the bag failing to collect grass. Is your bag the right fit for the tractor or mower, or is it universal? Lawn tractor baggers […]

By Alex October 1, 2025